If you have any questions, feel like you received this message in error or would like suggestions on other brands please contact us here. Unfortunately, due to vendor restrictions we are unable to sell this brand within Australia. Unfortunately, due to vendor restrictions we are unable to sell this brand within your country.
Unfortunately, due to vendor restrictions we are unable to sell this product or brand within California. If you have any questions, feel like you received this message in error or would like suggestions on other brands please contact us Here or call to speak to one of our experts. Unfortunately, we are not able to ship this item outside of the United States.
If you have any questions please contact us at: or Email Us Here. We'll refund the difference! Give us a call to get the best prices and parts for your build. Or, just call us with a cool racing story Email - sales maperformance. Phone It is a must for users who want highly accurate oil or fuel pressure readouts in their high performance vehicle.
A sweeping green LED needle lines the edge of the gauge face for quick reference. Thanks to an advanced single board design, X-Series Gauges have an incredibly slim overall depth of under 0. This warranty only applies to the original purchaser and is non-transferrable. If the product fails it would need to be determined by MAPerformance that it is due to manufacturing defects in materials or workmanship. This does not cover normal wear and tear. After rocking the boards several times apply upward force and the top board will begin to loosen.
As it begins to loosen, carefully pry up on the side of the top board that connects to the bottom board. Reassemble the two circuit boards together by inserting the top board in to the bottom and pressing down on the top board evenly. Install the plastic bushings, aluminum nuts, and screws. When seated properly, the two boards will bottom out on the plastic bushings. Slide the assembly back in to the enclosure and thread in the bottom screws first, then side plate and side screws.
Once telemetry is configured, you can add the temperature sensor to your gaugeART design. Note that temperature sensors are not linear, so if you are adding marks in your design to indicate degrees, check the instruction sheet included with the sensor for approximate positioning.
Your E-mail Address. Terminal kits are available from AEM if you no longer have them. Installing the terminals to the wires requires specialty wire terminal crimpers. NOTE: proper terminal crimping is critical. ECU terminals require special crimping tools for open barrel terminals. Adding thermistor fluid temperature sensors for an input such as oil temperature requires opening the ECU and changing jumpers.
Opening your EMS enclosure may void your warranty.
0コメント